Box detection and maintenance course for cars
Under the supervision of a trained trainer and more than 10 years of experience in this field.
Custom Course in Canbyo Auto Service
Based on the graduation of many students from the Academy in the previous batches and obtaining a job opportunity after graduating from
The course, the training course qualifies graduates directly to practice the profession upon graduation from the Academy, and they have obtained the
A certificate that entitles them to practice the profession and open a business of their own.
____________________________________
Course methodology:
The course methodology is based on 20% of the theoretical training and 80% of the training
Practical, given that we have a training laboratory equipped with all the requirements for training.
Targeted to participate in the training course:
The course targets the general public and everyone who wishes to participate and benefit from the training course, and to obtain a profession that enables him to work in it
And increase his monthly income, and the target ages to register for the course from 12 years and older
Knowing that we have a training factory equipped with all the requirements for training.
The main themes of the training course:
Introduction to control systems, car computer, engine, protection and cambio systems
Use an outside-car box tester launch x431
The use of a signal reader
Understanding pinout electrical maps
Using the most powerful box in the world of MST9000
The smd electrical element is a method of detection and maintenance, decoding and installation by caustic and hot air
Software reading and writing
Read and write EEPROM on board or outside for EEPROM decoding and mounting plate
Determine malfunctions of ignition systems, fuel, sensors, networks, and other hardware faults and repair
Clear crash
Dtc remove -11
Immo off – 12
Ali Box B revealed the detection device outside a car
Some devices used
1 ktag
2 kess
3 vvdi prog
4 car prog
-5 xprog
6 bdm
7 bdm table
8 iprog
9 xtool
10-MST9000
11-Automotive oscilloscope
The trainee will be able to diagnose and maintain any faults in the car box
Read and write software books from old to new
Some examples of DTC REMOVE
Cancel the IMMO OFFF system
Disassemble and install electronic components
Understanding and analyzes of electrical lathes
Using the Internet to find some difficult and new solutions
Using maintenance software, Auto data, GDS,
Diagnostic box outside the car with a launch x431 computer detector or any Ond2 device
Certificates are granted to all trainees certified by Next Academy for Training at the end of the training course and upon the student’s success in the final exam.
Registration is open from the date you see this advertisement until you take a sufficient number.
Those wishing to register must come to the company’s headquarters and confirm their reservation, to pay the course fees in full and before we take the sufficient number (places are limited).
Or, you can initially register by sending a text message to our numbers, or sending it by Viber or WhatsApp, and the message contains: Name, phone number, and the name of the course you wish to register for, on the numbers at the bottom of the advertisement.
______________________
For any inquiries, please call: 0928939481 – 0910933768 – 0921779318.
Or contact us with Viber or WhatsApp at the two numbers: 0928939481 – 0925159691.
Address: Tripoli – Al-Nawfleen – Sheikh Street – near Bab Tajoura Bridge. _
Visit our page on Facebook
https://www.facebook.com/next.academic
Join us and Register:
https://nextacademy.ly/initial-registration/
